file.newsgroup.cars.102923 Maven / Gradle / Ivy
From: [email protected] (Ken R. Dye )
Subject: Re: Feedback requested on lowering '66 Mustang
In article [email protected] (Jeff Perry) writes:
>I have found a kit advertised for lowering the front end of an early
>mustang. Installation envolves moving the upper A-arm and installation
>of a wedge shaped spacer between the A-arm and ball joint. Apparently,
>Shelby Mustangs did a similair modification, but left out the spacer.
>
>I would be interested in feedback, pro or con, on such a modification.
I'm no mustang head, but don't the early ones have a simple
strut suspension (that is, with no upper A-arm)? Just a strut
going down to a lower control arm (single bushing: not an A-arm), with a
tension/compression rod locating it in the forward/backward direction?
Anyway, simple strut suspensions like this can be lowered just by using
shorter springs, cutting the springs, lowering the spring perch or shortening
the strut below the perch. In each of these cases, the suspension geometry
will suffer because the lower control arms will not be at the
intended angle. A spacer placed between control arm and the bottom
of the strut (roughly the height of the reduction) will restore
the suspension geometry. IMHO, the kit that includes the spacer
is the only way to go...
--Ken
--
Ken R. Dye an optimist is a guy |
Lachman Technology, Inc., Chicago that has never had |
(708) 505-9555 x341 much experience |
[email protected] archy |